A wholly owned subsidiary of Bombardier Recreational Products, Sea-Doo is a Canadian marquee known for their personal watercrafts.In addition to their PWCs, Sea-Doo also produces various sport and speed boats.
2000 Seadoo Rx Millenium Edition Specs License To JA registered trademark of the National Automobile Dealers Association, under license to J.D.Spray BOMBARDIER LUBE lubricant over all me- tallic components in engine compartment.
2000 Seadoo Rx Millenium Edition Specs Manual May BeNo parts of this manual may be reproduced in any form without the prior written permission of Bombardier Inc. This edition was primarily published to be used by watercraft mechanic technicians who are already familiar with all service procedures relating to Bombardier made watercraft. MODEL MODELS NUMBER RX.5513 RX International.5514 RX DI. RX DI International.5656 GTX DI.5649 GTX DI International.5659 HULL IDENTIFICATION NUMBER (H.I.N.) F08L0QA RX Models TYPICAL It is located on footboard at the rear of watercraft. Italic sub-title above exploded view indicate pertaining models. Section 06 FUEL SYSTEM Title indicates main procedure to be carried-out. To remove carburetors from engine, proceed as fol- Inspect parts for corrosion dammage (shaft, butterfly, lows: spring screw, check valve housing, etc.). Sub-sub-title in Remove air vent tube support. Right (starboard) DESS Digitally Encoded Security System The information and componentsystem descrip-. Before undertaking All new 1998 and later watercrafts manufactured any procedure, be sure that you have on hand all by Bombardier are certified to the United States the tools required, or approved equivalents. NOTE: Always use proper strength Loctite prod- uct as recommended in this Shop Manual. Adjusting Screw 2. Apply Loctite Primer N (PN 293 800 041) on threads and allow to dry. Put several drops of proper strength Loctite threadlocker on female threads and in hole. Remove old gasket and other contaminants with Loctite Chisel remover (PN 413 708 500). Follow instructions on Loctite FORM-A-THREAD Use a mechanical mean if necessary. PN 413 708 600) package. NOTE: Avoid grinding. If a plate is used to align bolt: 2. Clean inner housing diameter and outer gasket diameter. Clean shaft external part and element internal part. ![]() Apply a strip of proper strength Loctite on shaft circumference at insert or engagement point. When they are not specified refer to following table.The table also gives the metric conversion. Nm FASTENER SIZE (8.8) Lbfin Nm FASTENER SIZE (8.8) Lbfft SMR200003600A2.FM. Fuel pressure gauge PN 420 277 905 PN 295 500 258 PN 529 035 709 41 cm (16 in) 2. MPEM programmer PN 529 035 718 F01B1O4 F01D885 APPLICATION 1) Puller assy All models. Medium strength threadlocker High temperature threadlocker Retaining compound PN 293 800 060. Flushing Flushing the cooling system with fresh water is essential to neutralize corroding effects of salt or other chemical products present in water. Quick connector adaptor Start the engine then immediately open the water 1. DI Models WARNING Spray, through hole of air intake silencer. Do not touch any electrical parts or jet pump NOTE: An increase of engine RPM may be noticed area when engine is running. Make sure there is no sand or other particles in it and that it is not obstructed so that water can leave the engine. WARNING Fuel is flammable and explosive under cer- tain conditions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |